<> [On Ranet A (via console)] : (Go to Desktop Tab > Terminal) Router>en Router#conf t Enter configuration commands, one per line. End with CNTL/Z. Router(config)#hostname RanetA RanetA(config)#enable secret ranetenablepass RanetA(config)#line con 0 RanetA(config-line)#password ranetconsolepass RanetA(config-line)#login RanetA(config-line)#line vty 0 4 RanetA(config-line)#password ranettelnetpass RanetA(config-line)#login RanetA(config-line)#int fa0/0 RanetA(config-if)#no sh %LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up RanetA(config-if)#ip add 10.0.0.1 255.255.255.252 RanetA(config-if)#int fa0/1 RanetA(config-if)#no sh %LINK-5-CHANGED: Interface FastEthernet0/1, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to up RanetA(config-if)#ip add 192.168.0.254 255.255.255.192 RanetA(config-if)# RanetA# %SYS-5-CONFIG_I: Configured from console by console RanetA#copy run start Destination filename [startup-config]? Building configuration... [OK] RanetA#ping 10.0.0.2 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 10.0.0.2, timeout is 2 seconds: .!!!! Success rate is 80 percent (4/5), round-trip min/avg/max = 2/3/5 ms RanetA# [On Ranet PC] : (Go to Desktop Tab > Command Prompt) Packet Tracer PC Command Line 1.0 PC>telnet 192.168.0.254 Trying 192.168.0.254 ...Open User Access Verification Password: ranettelnetpass RanetA>